
SCORER USER’S MANUAL
10
F I G U R E 27
USING PERFECTBACK™ LF
STRIPS (continued)
VI
Assembling your Document (continued)
1. Your cover should still be under the transparent bar.
With the Centering Guide in its last position, slide
your cover over so its right edge bends down
slightly, and stops against the partial step at the flat
yellow triangle (figure 27). Push the lever to the
right to hold down your cover.
2. On the front of your bound book block, peel off the
thin release paper (figure 28).
3. Fold your cover up to the left so it rests against the
side of the Die Holder (figure 29). Run your finger
back and forth at the bottom at the spine area of
the cover so it makes a sharp fold at the bottom.
4. Lay the book block, front facing up, on the right side
of the Platform with its bottom edge resting against
the Guide Rail (figure 30). It is OK if part of it rests
on top of the Centering Guide. Push the spine of
the book block against the spine portion of your
cover that is folded up.
5. With the book spine pushed fully and firmly to the
left, fold the cover over the front of your book block
(figure 31). Starting at the middle, rub down back
and forth to secure the cover to the adhesive.
6. Release the clamp by bringing the Lever to the
upright position. Remove the partially bound book
and turn over. On the back side remove the thin
release paper (figure 32).
7. Now fold the cover tightly all the way over the top
of the book block. Rub back and forth on the top
near the spine (figure 33) to secure the adhesive
beneath the cover.
8. Trim the book ends as desired.
Handheld document assembly
See the next page for an alternate method of assembly
which some people prefer. It does not require an assist
from the machine.
F I G U R E 32
F I G U R E 28
F I G U R E 29
F I G U R E 31
F I G U R E 33
30
F I G U R E 27
Kommentare zu diesen Handbüchern