
SCORER USER’S MANUAL
17
V
USING PERFECTBACK™ TA
STRIPS (continued)
Assembling your Document (continued)
1. Your cover has a total of four scores in the spine
region. Fold your cover at the two middle scores
(figure 73). These are the scores that are the same
distance apart as the thickness of your book block.
2. Peel off the release liner from the back of your
cooled book block (figure 74). Then, insert the
book block into your cover (figure 75). Make sure
the front page is under the front of your cover.
3. With the PERFECTBACK setting on your Fastback®
binder, bind your cover and book block together.
4. Trim the book ends as desired.
B. SINGLE DIE HOLDER USE
Scoring Your Cover
Using the Single Die Holder requires one scoring action
for each score you want to make.
1. With your Fastback®binder set in PERFECTBACK mode,
bind your pages only with a Perfectback™ TA strip.
2. After it has cooled, place your bound book block
between the Book Thickness Rings (Figure 76).
Push the two rings together (A) and tighten the
Book Thickness Locking Knob (B). Remove your
book block.
3. Slide your cover under the transparent bar until your
title is centered under the single silver line
(Figure 77). Make sure the bottom of your cover
rests against the Left Stop and the Guide Rail. Push
the Lever to the right so your cover will not move.
4. With the Centering Guide Locking Knob loosened,
slide the Centering Guide under your cover until the
right edge of the cover lines up with the middle of
the X (Figure 78). Then tighten the Centering Guide
Locking Knob (B).
(Continued on the next page)
F I G U R E 75
F I G U R E 73
F I G U R E 74
F I G U R E 77
F I G U R E 76
F I G U R E 78
Kommentare zu diesen Handbüchern